LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 2004 >> S80 Base, 2.5 59, FWD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Transmission - Removal, Replacement And Installation - 2 Of 2 >> Transmission, Automatic (B6284T, 4T65EV-Gt; 1999-2001) >> Installing the sealing ring and piston with O-ring for the front servo >> Installation >> Tightening the ball joint pinion and the anti-roll bar link

Tightening the ball joint pinion and the anti-roll bar link

Fig 1: Locating Ball Joint Nut
GLL109805Courtesy of VOLVO CARS OF NORTH AMERICA.
NOTE:

Counterhold the ball joint pinion while tightening so that the ball joint boot cannot turn. Tighten to 80 Nm  .

Tightening the anti-roll bar link 

Use a new lock nut.

NOTE:

Counterhold the ball joint pinion while tightening so that the ball joint boot cannot turn. Tighten to 50 Nm  .

scientia non olet · About LEMON Manuals