Installing all the charge air pipes

Fig 1: Identifying Charge Air Pipes

Courtesy of VOLVO CARS OF NORTH AMERICA.

Applies only to turbocharged cars 

Connect all the charge air pipes to each other.

Tighten the hose clamps.

Install the screws for the charge air pipe in the intake manifold. Tighten to 10 Nm  .

Fig 2: Identifying Heater Hoses And Clamp

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install the hose on the heater pipe in the bulkhead.

Press the radiator hose quick-release connector into place on the heater pipe.

Check:  Pull the hose.