LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 2004 >> S80 Base, 2.5 59, FWD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Transmission - Removal, Replacement And Installation - 2 Of 2 >> Transmission, Automatic (Ambulance; 2001-2002) >> Sealing ring, gear shift linkage rod, replacing >> Checking and adjusting the gear-shift position sensor >> Installing the cable duct

Installing the cable duct

Fig 1: Identifying Gear-Shift Position Sensor
GLL109388Courtesy of VOLVO CARS OF NORTH AMERICA.

Install the cable duct on the screw. Tighten to 25 Nm  .

Install the lever on the control shaft. Tighten to 16 Nm  .

scientia non olet · About LEMON Manuals