LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 2004 >> S80 Base, 2.5 59, FWD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Transmission - Removal, Replacement And Installation - 1 Of 2 >> Auxiliary Transmission, Bevel Gear And Overdrive (Ambulance; 2001-2002) >> Sealing rings bevel gear, replacing >> Sealing ring for driveshaft front right side, replacing >> Installing a new sealing ring

Installing a new sealing ring

Fig 1: Identifying Installing A New Sealing Ring
GLL109852Courtesy of VOLVO CARS OF NORTH AMERICA.

Install the new sealing ring for the drive shaft.

Lubricate the seal with wheel bearing grease, P/N 1161241-3.

Use drift 9995654 . Tap in the ring to stop.

If also replacing the seal for the crown wheel shaft, proceed to Sealing ring for crown wheel shaft for bevel gear, replacing .

NOTE:

To install the drive shaft, see.

scientia non olet · About LEMON Manuals