Installing the torque converter screws

Fig 1: Identifying Torque Converter Screw

Courtesy of VOLVO CARS OF NORTH AMERICA.

NOTE:

Use new screws, Torx TX50.

Align the torque converter against the carrier plate. Do this by turning the engine with the nut for the crankshaft pulley and turning the torque converter.

Install all 6 screws loosely. Tighten the screws to light contact against the carrier plate. Then tighten to 35 Nm . Use a Torx socket TX50. Counterhold at the pulley.

NOTE:

Remove the socket wrench from the crankshaft.