LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 2004 >> S80 Base, 2.5 59, FWD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Engine And Transmission - Removal And Installation >> Engine Mechanical >> Engine/transmission, removing/installing >> Drive shaft, right, replacing >> Installation >> Installing the drive shaft in the gearbox

Installing the drive shaft in the gearbox

Fig 1: Bearing Cap And Drive Shaft Support Bearing
GLL109802Courtesy of VOLVO CARS OF NORTH AMERICA.

Lubricate the drive shaft mating surface. Use wheel bearing grease P/N 116 1241-3 (80 g).

Install the drive shaft on the gearbox and the mounting for the pilot bearing with the bearing cap and the 2 M8 screws. Tighten.

Install the drive shaft to the wheel hub. See:

scientia non olet · About LEMON Manuals