Installing brake components on the wheel spindle

Fig 1: Brake Components

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install: 

• the brake caliper. Use new screws. Tighten to 100 Nm 
• the screw for the drive shaft. Use a new screw. Counterhold using a screwdriver in the brake disc vents. Tighten. See Summary of tightening torques for specific components
• the ABS sensor. Check that the sensor seat in the wheel spindle is free of dirt. Tighten to 10 Nm  .

Install the wheel 

See Installing wheels .