Front Wheel Hub Steel: Removal

Removing brake calipers 

Fig 1: Brake Caliper And Limiter Mounting Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove: 

• the wheel
• the brake caliper and limiter screws.

  Hang the caliper up using a piece of wire.

Fig 2: Identifying Drive Shaft Screw Removal Using A Screwdriver As A Counter Hold On Brake Disc

Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove: 

• the drive shaft screw. Use a screwdriver as a counterhold on the brake disc
• the locating pin holding the brake disc
• the brake disc.

Remove the end of the drive shaft 

Fig 3: Hub Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

Slacken off the end of the drive shaft in the hub by knocking the drive shaft into the hub approximately 10-15 mm  . Use a rubber or copper mallet.

Press the end of the drive shaft into the hub 10-20 mm  .

Remove the 4 screws for the hub.