Front Wheel Hub Steel: Installation

Installing the hub 

Fig 1: Hub Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Install the hub. Use new screws
• Press in the end of the drive shaft 10-20 mm 
• Use sleeve 3/8 mounting
• Tighten the screws for the hub alternately. First tighten to 20 Nm  . Then tighten to 65 Nm 
• Then angle-tighten to 60°  .

  See Screwed joint, torque/angle joint .

Installing the brake disc 

Fig 2: Installing Brake Disc

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install the brake disc.

Tighten the brake disc locating pin. Tighten to 8 Nm  .

Tighten the new drive shaft screw. See Summary of tightening torques for specific components .

Use bevel protractor 9512050 .

Installing brake calipers 

Fig 3: Brake Caliper And Limiter Mounting Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Install the brake caliper and the limiter
• Use new screws
• Tighten to 100 Nm 
• Install the wheel. See Installing wheels .