Installing The Right Control Arm

Fig 1: Identifying Right Engine Mounting Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Install the control arm. Use new screws
• Tighten the front screws. Tighten to: Tightening torque . Use protractor 9512050
• Tighten the rear screw and the nut. Tighten to: Tightening torque
• Lower the engine
• Remove the mobile jack
• Tighten the screws on the right engine mounting. Tighten to 35 Nm  . Angle-tighten 90°  . Use new screws.

Applies only to cars with 6 cylinder engines: 

• Install the oscillation damper. Use new screws. Tighten to: Tightening torque