LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 2004 >> S80 Base, 2.5 59, FWD >> Repair and Diagnosis >> Steering >> Power Steering >> Steering - Removal, Replacement And Installation >> Steering Wheel, Steering Wheel Lock, Steering Column, Shaft (2005-2006) >> Steering shaft, lower, replacing >> Installation >> Installing the needle bearing

Installing the needle bearing

Fig 1: Identifying Needle Bearing In Boot
GLL104671Courtesy of VOLVO CARS OF NORTH AMERICA.

Ensure that the needle bearing in the boot is in the groove. Lubricate the needle bearing in the boot with low temperature grease

NOTE: If necessary, make sure that the plain bearing is properly seated. Lubricate the plain bearing in the boot with low temperature grease, part no. 1161427-8 (6 grams).

Lubricate the edge on the inside of the inner part of the gaiter with soapy water.

scientia non olet · About LEMON Manuals