Intermittent fault
- Ignition off.WARNING:
Under no circumstances use an ohmmeter or other live measuring instrument to take readings on a disconnected, non-deployed, pyrotechnical seat belt tensioner. This could deploy the seat belt tensioner
CAUTION:Do not touch the terminal pins in the SRS control module. There is a risk of static discharge. This could damage the SRS control module.
Check the connectors for the SRS module and seat belt tensioner for contact resistance and oxidation according to Contact resistance and oxidation and for loose connections according to Loose connections (terminals) .
Check the cable between the SRS control module and the connector terminal for the seat belt tensioner as follows:
for diagnostic trouble code (DTC) SRS-0065,
terminals #5A (5), #6A (6) of the front left seat belt tensioner and connector terminals #1, #3.
for diagnostic trouble code (DTC) SRS-006D,
terminals #5C (1), #6C (2) of the front right seat belt tensioner and connector terminals #1, #3.
for diagnostic trouble code (DTC) SRS-0075,
terminals #16A (16), #15A (15) of the rear left seat belt tensioner and connector terminals #1, #3.
for diagnostic trouble code (DTC) SRS-007D,
terminals #17A (17), #18A (18) of the center rear seat belt tensioner and connector terminals #1, #3.
for diagnostic trouble code (DTC) SRS-0085,
terminals #16C (12), #15C (11) of the rear right seat belt tensioner and connector terminals #1, #3.
for an intermittent short-circuit to ground according to Short-circuit to ground, intermittent faults .
Remedy as necessary.
Other information:
- To access / replace the SRS control module and connectors, see Supplemental restraint system module (SRS), replacing .
- To replace the seat belt tensioner, see Seat belts, replacing .
- To connect the breakout box, see Connecting the breakout box .
- With the ignition off and the connector for the seat belt tensioner and for the SRS control module disconnected, the resistance between terminals #1 and #3 of the seat belt tensioner connector (SRS control module side) should read infinity.
- With the ignition off and special tool 9511506 connected, the resistance between the different terminals for each diagnostic trouble code (DTC) (see above) on the SRS control module connector (seat belt tensioner side) should be infinite.
- For information about the repair of SRS wiring, see Cable harness SRS system, repair .
- For other values, see Signal specification .
- Continue
Refer to Information