Checking components

Fig 1: Identifying Ignition ON

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Identifying Connector(s) Disconnected

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Ignition off.
• Disconnect connector from the right inflatable curtain.
• Connect the special tool 9511506 to the right inflatable curtain connector.
• WARNING:

  Never use an ohmmeter or any other charged measuring instrument on a disconnected, undeployed explosive inflatable curtain. There is a risk that the inflatable curtain could be deployed

  NOTE:

  The special tool must be checked and fault-free. If the special tool is defective, the wrong diagnosis will be displayed and troubleshooting will be more difficult.

• Ignition on, wait for approximately 10 seconds.

  Read the diagnostic trouble codes.

  If the diagnostic trouble code status changes from permanent to intermittent fault, replace the right inflatable curtain.

  Additional information: 

  • To access/replace the right inflatable curtain, see IC (inflatable curtain) module, replacing
  • To check the special tool, see Calibration .
  Fig 3: Identifying VCT2000 Diagnostic Tool Symbol In VIDA

  Courtesy of VOLVO CARS OF NORTH AMERICA.

Does the status of the diagnostic trouble code change? 

• YES 

  Refer to Verification 

• NO 

  Refer to Checking components and wires