Checking component

Fig 1: Identifying Ignition ON

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Identifying Connector(s) Disconnected

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Ignition off
• Disconnect the connector from the right-hand inflatable curtain
• Connect special tool 9511506 to the connector for the right-hand inflatable curtain
• WARNING:

  Under no circumstances use an ohmmeter or other live measuring instruments to take readings on a disconnected, non-deployed, pyrotechnical inflatable curtain. This could deploy the inflatable curtain

  NOTE:

  The special tool must be checked and fault-free. If the tool is defective, the diagnosis readings will be incorrect. This will make fault-tracing harder.

• Switch on the ignition. Wait 10 seconds.

  Read off diagnostic trouble codes (DTCs).

  If the status of the diagnostic trouble code (DTC) changes from permanent fault to intermittent fault, try replacing the right-hand inflatable curtain.

  Other information: 

  • To access and replace the right-hand inflatable curtain, see IC (inflatable curtain) module, replacing
  • To check the special tool, see Calibration .
  Fig 3: Identifying VCT2000 Diagnostic Tool Symbol In VIDA

  Courtesy of VOLVO CARS OF NORTH AMERICA.

Does the status of the diagnostic trouble code (DTC) change? 

• YES 

  Refer to Verification 

• NO 

  Refer to Checking components and wiring