Intermittent fault
- Ignition off.WARNING:
Under no circumstances use an ohmmeter or other live measuring instruments to take readings on a disconnected, non-deployed, pyrotechnical inflatable curtain. This could deploy the inflatable curtain
CAUTION:Do not touch the terminal pins in the SRS control module. There is a risk of static discharge. This could damage the SRS control module.
Check the connectors for the SRS module and inflatable curtain. Check for contact resistance and oxidation. See Contact resistance and oxidation . Check for loose connections. See Loose connections (terminals) .
Check the cable terminals in the female and male ends of the connector. The cable terminals must not be damaged or pressed back.
Check the cable between SRS control module terminals #21A (21) and #22A (22) and connector terminals #1 and #3 on the left-hand inflatable curtain for an intermittent open-circuit according to Open-circuit, intermittent faults .
Remedy as necessary.
Other information:
- To access and replace the SRS control module connector, see Supplemental restraint system module (SRS), replacing
- To access and replace the connector for the left-hand inflatable curtain (IC), see IC (inflatable curtain) module, replacing
- To connect the breakout box, see Connecting the breakout box
- With the ignition off and the inflatable curtain connector disconnected, the resistance between the inflatable curtain connector terminals #1 and #3 (SRS control module side) should be approximately 22 kΩ.
- For information about the repair of SRS wiring, see Cable harness SRS system, repair
- For other values:
1999-2004
- See Signal specification .
2005-2006
- See Signal specification .
- Continue
Refer to Information