Intermittent fault
- Ignition off.WARNING:
Under no circumstances use an ohmmeter or other live measuring instruments to take readings on a disconnected, non-deployed, pyrotechnical inflatable curtain. This could deploy the inflatable curtain
CAUTION:Do not touch the terminal pins in the SRS control module. There is a risk of static discharge. This could damage the SRS control module.
Check the connectors for the SRS module and inflatable curtain. Check for contact resistance and oxidation according to Contact resistance and oxidation . Check for loose connections according to Loose connections (terminals) .
Check the cable between the SRS control module terminals #21A (21) and #22A (22) and connector terminals #1 and #3 on the left-hand inflatable curtain for an intermittent short-circuit to ground according to Short-circuit to ground, intermittent faults .
Remedy as necessary.
Other information:
- To access and replace the SRS control module connector, see Supplemental restraint system module (SRS), replacing
- To access and replace the connector for the left-hand inflatable curtain (IC), see IC (inflatable curtain) module, replacing
- To connect the breakout box, see Connecting the breakout box
- With the ignition off and with the left-hand inflatable curtain connector and special tool 9511506 connected, the resistance between terminals #A21 (21) and #A22 (22) on the SRS control module connector (inflatable curtain side) should be infinite
- With the ignition off and the connectors for the left-hand inflatable curtain and for the SRS control module disconnected, the resistance between terminals #1 and #3 on the inflatable curtain connector (SRS control module side) and ground should be infinite
- For information about the repair of SRS wiring, see Cable harness SRS system, repair
- For other values:
1999-2004
- See Signal specification .
2005-2006
- See Signal specification .
- Continue
Refer to Information