Installing rear seat belt (inertia) reels

Fig 1: Identifying Rear Seat Belts

Courtesy of VOLVO CARS OF NORTH AMERICA.

NOTE:

Ensure that the guide for the end mounting is correctly positioned during installation. (The end mounting must be pointing forwards at an angle of 45°).

Install:

the screw for the end mounting. Tighten to 48 Nm
the seat belt (inertia) reel nuts. Tighten to 48 Nm
the connector. See Igniter wire connector
the parcel shelf.
the rear seat cushion. See Rear seat assembly
the seat belt in the seat belt guide
Then check the seat belt function. See.