Removing the condenser
Remove:
- the right AC pipe connection with the 1 screw.
- the connector of the pressure sensor
- the pressure sensor
- the lower right mounting with the 1 screw.
Undo the left AC pipe from the clip.
Remove the lower left mounting with the 1 screw.
Loosen the left headlight slightly but let the cables remain:
- For -2004 see: Headlamp/bulb, replacing
- For 2005- see: Headlamp/bulb, replacing .
Remove the left AC pipe with the 1 screw.
Remove the upper mountings on the condenser with the 2 screws.
The condenser is held in place by the left AC pipe.
Raise the vehicle.
Remove the condenser, moving it straight down. Press the AC pipe on the left side slightly to the side while pulling the condenser down.