Installing The Lever & The Gear-Shift Position Sensor

Install:

• the lever for the gear shift linkage rod. Tighten the nut. Tighten to 16 Nm.
• the lever on the gear shift linkage rod. Tighten to 16 Nm. The gear selector cable on the lever and transmission. Tighten to 25 Nm
• the connector for the gear-shift position sensor on the mounting.

Connect the connector. Assemble the cable harness with tie straps. Press the mounting for the cable harness into place in the cover for the control system. Install the mounting for the connectors on the bracket.