Engine management systems Fenix and Motronic

Fig 1: Identifying 43-Pin Connector

Courtesy of VOLVO CARS OF NORTH AMERICA.

To connect the breakout box to the Fenix and Motronic control systems which have 43+43-pin connectors (A+B):

Use two breakout boxes (A and B) with adapter 9511351 . The adapter is fitted with two connectors marked A and B.

Connector A (engine side) uses measurement terminals 1-43 on the breakout box A which correspond to #A1-#A43 on the control module.

Connector B (car side) uses measurement terminals 1-43 on the breakout box B which correspond to #B1-#B43 on the control module.

Fig 2: Identifying Fenix/Motronic

Courtesy of VOLVO CARS OF NORTH AMERICA.