Checking components and wiring
- Ignition off.
Check the resistance of the clutch pedal sensor between terminals #2 and #4 (component side).
Check the clutch pedal and engine control module (ECM) connectors. Check for contact resistance and oxidation.
Check the signal cable between engine control module (ECM) terminal #B15 (#B25) and clutch pedal sensor terminal #2 (component side). Check for an open-circuit.
Check the signal ground cable between engine control module (ECM) terminal #B4 (#B14) and clutch pedal sensor terminal #4 (cable harness side). Check for an open-circuit.
Check the clutch pedal sensor installation. Search for damage and check the connections visually.
HINT: With the ignition on, the power supply to the clutch pedal sensor must be approximately 5 V (measured with the clutch pedal sensor disconnected), measured between terminals #2 and #4 (cable harness side).
Remedy as necessary.
Other information:
- See Connecting the breakout box
- For information about signals for 5 cylinder engines: Signal specification
- For information about signals for 6 cylinder engines:
- For 6 cylinder engines -2001, see Signal specification
- For 6 cylinder engines 2002-, see Signal specification
- For 6 cylinder engines -2004, see Signal specification
- For 6 cylinder engines 2005-, see Signal specification .
- For resistance values: Component specifications
- See Contents
- Continue
Refer to Verification