Faulty signal. Permanent fault: Information: Overview

This diagnostic trouble code (DTC) indicates that the immobilizer code does not match between the engine control module (ECM) and the central electronic module (CEM). This may be because:

• the immobilizer code in the engine control module (ECM) is incorrect i. e. the code does not correspond to the code stored in the central electronic module (CEM)
• the engine control module (ECM) is not programmed and has no immobilizer code
• the immobilizer code in the central electronic module (CEM) is incorrect
• the central electronic module (CEM) is not programmed and has no immobilizer code
• the engine control module (ECM) is damaged
• the central electronic module (CEM) is damaged.

HINT: Read off the diagnostic trouble codes (DTCs) for the central electronic module (CEM). 

For further information about this diagnostic trouble code (DTC), select Information, then DTC information.

Other information: 

• To access and replace the engine control module (ECM), see Engine control module (ECM), replacing
• To access or replace the central electronic module (CEM), see Central electronic module (CEM), replacing
• For information about signals on 5-cylinder engines, see Signal specification
• For information about signals on 6-cylinder engines:
  • For 6 cylinder engines -2001, see Signal specification
  • For 6 cylinder engines 2002-, see Signal specification
  • For 6 cylinder engines -2004, see Signal specification
  • For 6 cylinder engines 2005-, see Signal specification .

• Continue 

  Refer to Verification