Checking component and wiring

Check the cable between Engine control module (ECM) #B46 and Driver information module (DIM) #2 for short-circuiting to ground according to: Checking wiring and terminals. Permanent fault

Remedy as necessary.

Other information: 

• For connection of engine control module (ECM) breakout box, see Connecting the breakout box .
• To connect the breakout box to the Driver information module (DIM), see: Connecting the breakout box
• To access/replace the combined instrument panel, see Driver information module (DIM), replacing
• For information about signals on 5-cyl engines, see Signal specification .
• For information about signals on 6-cylinder engines:
  • For 6 cylinder engines -2001, see Signal specification
  • For 6 cylinder engines 2002-, see Signal specification
  • For 6 cylinder engines -2004, see Signal specification
  • For 6 cylinder engines 2005-, see Signal specification .
• Signal description Driver information module (DIM): Signal specification

• Continue 

  Refer to Verification