Checking the components and wiring
Check the resistance on camshaft reset valve between terminals #1 and #2. Resistance must be approximately 3.7 Ω.
Check the signal cable between Engine control module (ECM) terminal #A13 and camshaft reset valve terminal #2. Check for an open-circuit, short-circuit to ground and short-circuit to voltage.
Check the power supply cable between system relay terminal #5 and camshaft reset valve terminal #1. Check for an open-circuit.
Remedy as necessary.
Other information
- See Checking wiring and terminals
- To connect the breakout box, see: Connecting the breakout box
- For 6 cylinder engines -2001, see Signal specification
- For 6 cylinder engines 2002-, see Signal specification
- For 6 cylinder engines -2004, see Signal specification
- For 6 cylinder engines 2005-, see Signal specification .
Was a fault detected?
- YES
Refer to Verification
- NO
Refer to Checking components