Checking component and wiring

Check the cable between #A38 (#A38) and turbocharger (TC) control valve #2 for a short-circuit to supply voltage according to Short-circuit to supply voltage. Permanent faults .

Remedy as necessary

Other information:

To connect the breakout box, see Connecting the breakout box .
For information about signals on 5-cylinder engines, see Signal specification .
For information about signals on 6 cylinder engines:
- For 6 cylinder engines -2001, see Signal specification
- For 6 cylinder engines 2002-, see Signal specification
- For 6 cylinder engines -2004, see Signal specification
- For 6 cylinder engines 2005-, see Signal specification .
To access/replace the turbocharger (TC) control valve, see Replacing the turbocharger (TC) control valve
Turbocharger (TC) control valve #1 has Ubat power supply from the system relay.

Fig 1: Brake Pedal Position Sensor Connector Terminal Identification

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Identifying Ohm Meter

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 3: Identifying Turbocharger Control Valve

Courtesy of VOLVO CARS OF NORTH AMERICA.