Checking for oil leakage and replacing the component: Notes
NOTE:
If diagnostic trouble codes (DTCs) ECM-540X and ECM-550X are stored at the same time, codes ECM-540X must be remedied first.
- Checking the engine for oil leakage
- Also check the oil level sensor connector. Check for loose connections, contact resistance or oxidation.
HINT: This diagnostic trouble code (DTC) may be stored if the engine oil is significantly mixed with fuel or coolant for example.
Try a new oil level sensor if no fault is found and the fault is permanent.
Remedy as necessary.
Other information:
- To connect the breakout box, see Connecting the breakout box
- For information about signals on 5 cylinder engines, see Signal specification
- For information about signals on 6 cylinder engines:
- For 6 cylinder engines -2001, see Signal specification
- For 6 cylinder engines 2002-, see Signal specification
- For 6 cylinder engines -2004, see Signal specification
- For 6 cylinder engines 2005-, see Signal specification .
- To access or replace the oil level sensor, see Oil level sensor, replacing
- See Checking wiring and terminals
- Continue
Refer to Verification