Fault-tracing information:
- The control module cannot run the leak diagnostic when the quick test of the fuel tank system is activated. This may be because the conditions for starting the quick test of the fuel tank system have not been met, that the fault occurred during fault-tracing or that the fault existed before the fault-tracing began. Check that all conditions for starting the quick test of the fuel tank system are met and that all hoses, connectors, components etc are correctly reinstalled and undamaged
- The quick test for the fuel tank system cannot be run if the battery voltage varies too much. The voltage may vary if the battery is being charged with a battery charger. Charge the battery before beginning the quick test to avoid voltage variations.
HINT: Cancel fault-tracing for this fault. Then read off diagnostic trouble codes (DTCs) from the vehicle communication socket. Fault trace any other diagnostic trouble codes (DTCs) stored in the control module.
- Remedy as necessary.
Select a suitable alternative to continue:
- Start this fault-tracing from the beginning again
- Cancel fault-tracing for this fault.
FAULT NOT FOUND: Troubleshooting has been completed.