Replacing the EVAP canister shut-off valve: Notes

Removing the EVAP canister shut-off valve 

Fig 1: Identifying EVAP Canister Shut-Off Valve

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Identifying Clamp Being Squeezed By Pipe Wrench

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Disconnect the connector

  Removing the clamp: 

  • squeeze the clamp with a pipe wrench. Hold in place
  • pry apart with a small screwdriver.
    NOTE:

    These are reusable.

• Remove the clamps (2) at the EVAP canister and rear axle joint, and one tie strap.

  Removing the clamp: 

  • squeeze the clamp with a pipe wrench. Hold in place
  • pry apart with a small screwdriver.
    NOTE:

    These are reusable.

• Disconnect hoses.
• Remove the rubber mounting from the bracket.