Checking the components and wiring: Notes
Check the resistance of the evaporative emission system (EVAP) valve.
Check the signal cable between engine control module (ECM) terminal #A9 (#A9) and evaporative emission system (EVAP) valve terminal #2. Check for a short-circuit to supply voltage.
HINT: Use an electrician's screwdriver with at least a 3 W bulb to determine whether there is a short-circuit to supply voltage in the cable.
Remedy as necessary.
Other information:
- See Connecting the breakout box
- For information about signals for 5 cylinder engines: Signal specification
- For information about signals for 6 cylinder engines:
- For 6 cylinder engines -2001, see Signal specification
- For 6 cylinder engines 2002-, see Signal specification
- For 6 cylinder engines -2004, see Signal specification
- For 6 cylinder engines 2005-, see Signal specification .
- See Component specifications
- For the location of components on 5 cylinder engines, see: Location of components
- Location of components, 6 cylinder normally aspirated engines:
- For 6 cylinder naturally aspirated engines -2001, see Location of components
- For 6 cylinder naturally aspirated engines 2002, see Location of components, engine compartment
- For 6 cylinder naturally aspirated engines 2003-, see Location of components, engine compartment .
- Location of components, 6 cylinder turbocharged engines:
- For 6 cylinder turbocharged engines -2001, see Location of components
- For 6 cylinder turbocharged engines 2002, see Location of components, engine compartment
- For 6 cylinder turbocharged engines 2003-, see Location of components, engine compartment .
- See Contents
- Continue
Refer to Verification