Checking the connector
- Ignition off
- Check the evaporative emission system (EVAP) valve connector. Check for contact resistance and oxidation
- Reinstall the components, reconnect the connectors etc.
- Ignition on
- Activate the evaporative emission system (EVAP) valve.
A click should be heard when the evaporative emission system (EVAP) valve is activated.
If the evaporative emission system (EVAP) valve is now OK this indicates that the fault was caused by poor contact in the connector.
Other information
- For information about signals for 5 cylinder engines: Signal specification
- For information about signals for 6 cylinder engines:
- For 6 cylinder engines -2001, see Signal specification
- For 6 cylinder engines 2002-, see Signal specification
- For 6 cylinder engines -2004, see Signal specification
- For 6 cylinder engines 2005-, see Signal specification .
- For the location of components on 5 cylinder engines, see: Location of components
- Location of components, 6 cylinder normally aspirated engines:
- For 6 cylinder naturally aspirated engines -2001, see Location of components
- For 6 cylinder naturally aspirated engines 2002, see Location of components, engine compartment
- For 6 cylinder naturally aspirated engines 2003-, see Location of components, engine compartment .
- Location of components, 6 cylinder turbocharged engines:
- For 6 cylinder turbocharged engines -2001, see Location of components
- For 6 cylinder turbocharged engines 2002, see Location of components, engine compartment
- For 6 cylinder turbocharged engines 2003-, see Location of components, engine compartment .
- See Contents
Courtesy of VOLVO CARS OF NORTH AMERICA.
Is the evaporative emission system (EVAP) valve working?
- YES
OKAY: Troubleshooting has been completed.
- NO
Refer to Checking the components and wiring