Checking the wiring
Check the signal cable for the valve between control module terminal #B40 (#B50) and leak diagnostic unit terminal #3. Check for a short-circuit to ground.
Remedy as necessary.
Other information:
- See Contents
- For resistance values, see Component specifications
- To connect the breakout box, see Connecting the breakout box
- For information about signals on 5 cylinder engines, see Signal specification
- For information about signals for 6 cylinder engines:
- For 6 cylinder engines -2001, see Signal specification
- For 6 cylinder engines 2002-, see Signal specification
- For 6 cylinder engines -2004, see Signal specification
- For 6 cylinder engines 2005-, see Signal specification .
- To access or replace the leak diagnostic unit, see Leak diagnostic pump, replacing
- Continue
Refer to Verification