Checking the connector

Fig 1: Identifying Ignition ON

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Connecting Connector

Courtesy of VOLVO CARS OF NORTH AMERICA.

Ignition off.
Check the canister valve's connector for contact resistance and oxidation acc. to: Checking wiring and terminals. Permanent fault
Restore components and connectors.
Ignition on.
Activate the canister valve.
A "click" sound must be heard when the canister valve is activated.

If the canister valve now is OK, this indicates that the problem has been caused by poor contact in the connector.

Other information
- To access/replace the canister valve, see: Replacing the shut-off valve for the carbon filter container
- For information about signals 5-cylinder engine, see: Signal specification
- For information about signals for 6 cylinder engines:
  - For 6 cylinder engines -2001, see Signal specification
  - For 6 cylinder engines 2002-, see Signal specification
  - For 6 cylinder engines -2004, see Signal specification
  - For 6 cylinder engines 2005-, see Signal specification .
Fig 3: Identifying EVAP Canister Shut-Off Valve Connector
Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 4: Identifying VCT2000 Diagnostic Tool Symbol In VIDA
Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 5: Identifying EVAP Canister Shut-Off Valve
Courtesy of VOLVO CARS OF NORTH AMERICA.

Does the canister valve work?