Checking the components and wiring: Notes
Check the canister valve's resistance.
Check the signal cable between control module #B40 (#B50) and canister valve, connection 2, and voltage supply between system relay, connection 3, and canister valve, connection 1, for open circuit: Checking wiring and terminals. Permanent fault
Remedy as necessary.
Other information
- See Connecting the breakout box
- To access/replace the canister valve, see: Replacing the shut-off valve for the carbon filter container
- See Component specifications
- For information about signals 5-cylinder engine, see: Signal specification
- For information about signals for 6 cylinder engines:
- For 6 cylinder engines -2001, see Signal specification
- For 6 cylinder engines 2002-, see Signal specification
- For 6 cylinder engines -2004, see Signal specification
- For 6 cylinder engines 2005-, see Signal specification .
- Continue
Refer to Verification