Tank system, test result = "No leakage found"
Diagnostic trouble code limit (minor leakage): Estimated leakage = 0.40 mm
If no leakage was found, the Engine control module (ECM) has detected leakage in the tank system earlier, but the problem is not active at this time. The fault could be caused by leakage in the tank, filler pipe, fuel tank filler cap, canister, EVAP valve, leakage diagnosis unit or hoses between these components.
NOTE:
Problems caused by a loose tank cap or loose hose connections may be difficult to find. If no leakage was found in the quick-test of the tank system after completed checks and actions according to the above, the problem has likely been repaired.
NOTE:
The parameter estimated leakage does not necessarily have to show 0 mm for a sealed system.