Checking components and wiring: Notes
Check the resistance of the evaporative emission system (EVAP) valve.
Check the signal cable between control module terminal #A9 (#A9) and evaporative emission system (EVAP) valve terminal 2. Check for a short-circuit to supply voltage.
HINT: Use a test lamp with at least a 3 W bulb to determine whether the cable is short-circuited to supply voltage.
Remedy as necessary.
Other information:
- To connect the breakout box / access the control module, see Connecting the breakout box
- For the location of components on 5 cylinder engines, see Location of components
- For the location of components on 6 cylinder normally aspirated engines:
- For 6 cylinder normally aspirated engines -2001, see Location of components
- For 6 cylinder normally aspirated engines 2002, see Location of components, engine compartment
- For 6 cylinder normally aspirated engines 2003-, see Location of components, engine compartment .
- For the location of components on 6 cylinder turbocharged engines:
- For 6 cylinder turbocharged engines -2001, see Location of components
- For 6 cylinder turbocharged engines 2002, see Location of components, engine compartment
- For 6 cylinder turbocharged engines 2003-, see Location of components, engine compartment .
- For resistance values, see Component specifications
- For information about signals on 5 cylinder engines, see Signal specification
- For information about signals for 6 cylinder engines:
- For 6 cylinder engines -2001, see Signal specification
- For 6 cylinder engines 2002-, see Signal specification
- For 6 cylinder engines -2004, see Signal specification
- For 6 cylinder engines 2005-, see Signal specification .
- See Contents .
- Continue
Refer to Verification