Checking components and wiring: Notes
- Check the connector for the ignition coil. Check for contact resistance. Check for oxidation.
Check the cable that relates to the diagnostic trouble code (DTC). Check for an open-circuit.
Check between:
- Engine control module (ECM) terminal #A50 (#A50) and ignition coil terminal #2 (ECM-360D, ignition coil 1)
- Engine control module (ECM) terminal #A51 (#A51) and ignition coil terminal #2 (ECM-361D, ignition coil 2)
- Engine control module (ECM) terminal #A30 (#A30) and ignition coil terminal #2 (ECM-362D, ignition coil 3)
- Engine control module (ECM) terminal #A49 (#A49) and ignition coil terminal #2 (ECM-363D, ignition coil 4)
- Engine control module (ECM) terminal #A31 (#A31) and ignition coil terminal #2 (ECM-364D, ignition coil 5)
- Engine control module (ECM) terminal #A52 (#A52) and ignition coil terminal #2 (ECM-365D, ignition coil 6).
Remedy as necessary.
Other information
- See Connecting the breakout box
- For 6 cylinder engines -2001, see Signal specification
- For 6 cylinder engines 2002-, see Signal specification
- For 6 cylinder engines -2004, see Signal specification
- For 6 cylinder engines 2005-, see Signal specification .
- See Replacing ignition coil
- See Contents
- Continue
Refer to Verification