Checking components and connectors
Check the camshaft position (CMP) sensor and control module connectors. Check for contact resistance and oxidation.
Check that the camshaft position (CMP) sensor is correctly installed and that neither the sensor or the housing is damaged. Damage may affect the position of the sensor in relation to the camshaft rotor.
Remedy as necessary.
Try a new camshaft position (CMP) sensor if no fault is found during the above fault-tracing.
Other information:
- To connect the breakout box / access the control module, see Connecting the breakout box
- For the location of components on 5 cylinder engines, see Location of components
- For the location of components on 6 cylinder turbocharged engines:
- For 6 cylinder turbocharged engines -2001, see Location of components
- For 6 cylinder turbocharged engines 2002, see Location of components, engine compartment
- For 6 cylinder turbocharged engines 2003-, see Location of components, engine compartment .
- For information about signals on 5 cylinder engines, see Signal specification
- For information about signals on 6 cylinder engines:
- For 6 cylinder engines -2001, see Signal specification
- For 6 cylinder engines 2002-, see Signal specification
- For 6 cylinder engines -2004, see Signal specification
- For 6 cylinder engines 2005-, see Signal specification .
- See Contents .
- Continue
Refer to Verification