Checking components and wiring: Notes
Check the resistance of the heated oxygen sensor (HO2S) between terminals #1 and #2.
Check the signal cable between heated oxygen sensor (HO2S) terminal #2 and control module terminal #A8 (#A8). Check for a short-circuit to supply voltage.
Remedy as necessary.
Other information:
- For information about signals on 5 cylinder engines, see Signal specification
- For information about signals on 6 cylinder engines:
- For 6 cylinder engines -2001, see Signal specification
- For 6 cylinder engines 2002-, see Signal specification
- For 6 cylinder engines -2004, see Signal specification
- For 6 cylinder engines 2005-, see Signal specification .
- To connect the breakout box / access the control module, see Connecting the breakout box
- To access or replace the heated oxygen sensor (HO2S), see Heated oxygen sensor (HO2S), replacing
- For resistance values, see Component specifications
- See Contents .
- Continue
Refer to Verification