Checking the connector

Fig 1: Engine Start Verification

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Connecting Connector

Courtesy of VOLVO CARS OF NORTH AMERICA.

Ignition off
Check the heated oxygen sensor (HO2S) connector. Check for contact resistance and oxidation
Reinstall the components, reconnect the connectors etc.
Start the engine. Allow the engine to idle.
Read off the status of the diagnostic trouble code (DTC) for the rear heated oxygen sensor (HO2S).

The text "NOT READY" is displayed if the diagnosis is running.

Other information
- To access or replace the heated oxygen sensor (HO2S), see Heated oxygen sensors (HO2S), replacing
- For information about signals:
  - For 6 cylinder engines -2001, see Signal specification
  - For 6 cylinder engines 2002-, see Signal specification
  - For 6 cylinder engines -2004, see Signal specification
  - For 6 cylinder engines 2005-, see Signal specification .
- See Contents .
Fig 3: Identifying Rear Heated Oxygen Sensor (HO2S) Connector
Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 4: Identifying VCT2000 Diagnostic Tool Symbol In VIDA
Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 5: Identifying Rear Heated Oxygen Sensor (HO2S)
Courtesy of VOLVO CARS OF NORTH AMERICA.

Is "FAULT NOT DETECTED" displayed?