Checking wiring and connectors

CAUTION:

Do not apply rust solvent spray or grease to the heated oxygen sensor (HO2S) connector.

Check the heated oxygen sensor (HO2S) connector. Check for contact resistance and oxidation. Check for loose connections.

Check the signal cable (+) between heated oxygen sensor (HO2S) terminal #4 and control module terminal #A10 (#A10). Check the signal cable (-) between heated oxygen sensor (HO2S) terminal #3 and control module terminal #A11 (#A11). Check for an intermittent open-circuit.

Other information:

To connect the breakout box and access the control module, see Connecting the breakout box
To access or replace the heated oxygen sensor (HO2S), see Heated oxygen sensor (HO2S), replacing
For information about signals:
- For 6 cylinder engines -2001, see Signal specification
- For 6 cylinder engines 2002-, see Signal specification
- For 6 cylinder engines -2004, see Signal specification
- For 6 cylinder engines 2005-, see Signal specification .
See Contents .

Fig 1: Identifying Rear Heated Oxygen Sensor (HO2S) Connector

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Identifying Ohmmeter

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 3: Identifying Rear Heated Oxygen Sensor (HO2S)

Courtesy of VOLVO CARS OF NORTH AMERICA.

Continue
Refer to Information