Checking fuel injection system: Notes
Check intake system for air leakage according to Check for air leaks in the intake system .
HINT: Air leakage in the intake system can occur through the canister purge (CP) valve, the secondary air solenoid valve and power brake booster.
Check fuel pressure according to Checking fuel and residual pressures .
Test drive the car for approximately 10 minutes
Check the mass air flow (MAF) sensor by read off its correction factors. The value should be between 0.8 and 1.2
NOTE:
There must not be any air leakage when this test is carried out.
Remedy as necessary.
Other information
- To access/replace the mass air flow (MAF) sensor, see Mass air flow sensor (MAF), replacing .
- Continue
Refer to Verification