Checking the wiring

Check the cable between injector terminal 2 and control module:

terminal #A16 (#A16) (ECM 2310)
terminal #A15 (#A15) (ECM 2320)
terminal #A33 (#A33) (ECM 2330)
terminal #A32 (#A32) (ECM 2340)
terminal #A34 (#A34) (ECM 2350)
terminal #A14 (#A14) (ECM 2360).

Check for an intermittent short-circuit to supply voltage.

Other information

To connect the breakout box / access the control module, see Connecting the breakout box
To access or replace the injector, see Injectors/pulsation dampers, replacing
For information about signals:
- For 6 cylinder engines -2001, see Signal specification
- For 6 cylinder engines 2002-, see Signal specification
- For 6 cylinder engines -2004, see Signal specification
- For 6 cylinder engines 2005-, see Signal specification .
See Contents .

Fig 1: Identifying Injector Connector Terminals

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Identifying Voltage Display

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 3: Identifying Injector

Courtesy of VOLVO CARS OF NORTH AMERICA.