Checking the connector

Fig 1: Identifying Ignition ON

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Connecting Connector

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Ignition off
• Check the injector connector. Check for contact resistance and oxidation
• Reinstall the components, reconnect the connectors etc.
• Ignition on
• Activate the injector.

  A "click" should be heard when the injector is activated.

  If the injector is now OK, the fault was caused by poor contact in the connector.

  Other information 

  • To access or replace the injector, see Injectors/pulsation dampers, replacing
  • For information about signals:
    • For 6 cylinder engines -2001, see Signal specification
    • For 6 cylinder engines 2002-, see Signal specification
    • For 6 cylinder engines -2004, see Signal specification
    • For 6 cylinder engines 2005-, see Signal specification .
  • See Contents .
  Fig 3: Identifying Injector Connector Terminals

  Courtesy of VOLVO CARS OF NORTH AMERICA.
  Fig 4: Identifying VCT2000 Diagnostic Tool Symbol In VIDA

  Courtesy of VOLVO CARS OF NORTH AMERICA.
  Fig 5: Identifying Injector

  Courtesy of VOLVO CARS OF NORTH AMERICA.

Is the injector working? 

• YES 

  OKAY:  Troubleshooting has been completed.

• NO 

  Refer to Checking components and wiring