Draining The Fuel Tank: Preparation

Disconnect the battery negative lead. See Battery, disconnecting

WARNING:

RISK OF EXPLOSION THE USE OF A FRESH AIR MASK IS RECOMMENDED.

Insert the heavy duty hose 1.3 meters into the fuel filler pipe, measured from the edge of the opening of the filler pipe.

Pump until air comes out.

Fig 1: Identifying Screw And Connector At Seat Hinge

Courtesy of VOLVO CARS OF NORTH AMERICA.

(S80, S60) Remove the seat cushion for the rear seat.

Remove the right side cushion. See Side cushion, replacing

Disconnect the connector at the hinge.

Remove:

Release the strap/straps of the folding mechanism for the seat belt buckle. (Hooked into place on the lower edge of the backrest).

Lift out the backrest.

Fig 2: Identifying Pushing Carpet Aside And Locating Level Sensor/Fuel Pump Cover

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fold the carpet (1) out of the way.

Remove the insulation panel.

Cover the area (2) around the cover and between the doors with absorbent material.

CAUTION:

Ensure that there is no risk of dirt getting into the tank.