Throttle Body (Electronic Throttle Module (ETM)), Replacing: Removing

• Disconnect the negative battery lead. Battery, disconnecting
• the dipstick tube

Fig 1: Identifying Dipstick Tube

Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove the intake manifold between the throttle body (TB) and the air cleaner.

Fig 2: Identifying Cylinder Block Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

If the wiring to the throttle body is behind the bracket for the starter motor:

Slacken off the nuts (x 2).

Remove the screw.

Remove any tie straps and disconnect the connector for the throttle body.

Route the wiring for the throttle body from the reverse of the bracket for the starter motor.

Fig 3: Identifying Throttle Body And Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove the 4 x screws for the throttle body.