Heated Oxygen Sensors (HO2S), Replacing: Installation
- Use tool
9995543
.
Install the heated oxygen sensor (HO2S). Tighten to 45 Nm
- Install the mounting for the cable harness
- Route the cable harness. Connect the connector.
CAUTION:
Ensure that the cable harness does not rub and is not pinched.
- Install the heat deflector plate
- Carefully raise the mobile jack to the installation position for the exhaust system
- Install the front member. Tighten to 25 Nm
.NOTE:
Do not reinstall the rivets.
- Reconnect the exhaust flange. Tighten to 25 Nm
- Install the center member. Tighten to 25 Nm
.NOTE:
Do not reinstall the rivets.
- Reinstall the rubber pads for the exhaust mounting. Tighten to 25 Nm .
CAUTION:
Check that the exhaust system is not rubbing. Check that the exhaust system is not in contact with the bodywork or other components.
- Remove the mobile jack.