Crankcase Ventilation, Cleaning 6-Cyl Non-Turbo: Cleaning

Fig 1: Locating Hole In Intake Pipe

Courtesy of VOLVO CARS OF NORTH AMERICA.

Disconnect the hose with the T nipple from the intake pipe.

Remove 9995723

Clean the hole in the intake pipe using a Ø 2 mm drill bit.

Remove the hose from the T nipple.

Clean the T nipple. Use a Ø 2 mm drill bit.

Clean the hose using a Ø 2 mm cable and blow clean using compressed air

Clean the inlet pipe air duct.

Install: 

• the hose on the T nipple
• the hose with the T nipple to the intake pipe.
• cover 9995723