Installing The Front Camshaft Seal: Finishing

Install: 

• the starter motor. Tighten screws at gearbox. Tighten. See Tightening torque .
• the screw at the support bracket for the starter motor. Tighten
• the trigger wheel. Tighten the screw
• the camshaft position (CMP) sensor housing. Tighten the screws
• a new cover at the rear edge of the camshaft.

Install the auxiliaries belt around the pulley on the crankshaft.

Install: 

• the plastic nuts for the cover in the right-hand wing liner
• the right front wheel. See Installing wheels .

Fig 1: Expansion Tank And Servo Reservoir

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install: 

• front timing cover. Tension the auxiliaries belt. Check that it is correctly positioned on all pulleys
• the expansion tank
• the hose between the expansion tank and the radiator. Remove the lock grip pliers
• the servo reservoir
• the upper timing cover.

Fig 2: Identifying Trigger Wheel, Camshaft Position (CMP) Sensor Housing, Air Cleaner (ACL) Cover, Intake Manifold Between Electronic Throttle Module (ETM) & Engine Stabilizer Brace

Courtesy of VOLVO CARS OF NORTH AMERICA.

• the engine stabilizer brace. Tighten the screws
• the screw holding the engine stabilizer brace to the bracket on the engine. Tighten
• the battery negative lead. Also read Battery, disconnecting .