Removing/Installing The Rear Camshaft Seal: Finishing

Fig 1: Identifying Trigger Wheel, Camshaft Position (CMP) Sensor Housing, Air Cleaner (ACL) Cover, Intake Manifold Between Electronic Throttle Module (ETM) & Engine Stabilizer Brace

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install: 

• the trigger wheel. Tighten the screw
• the camshaft position (CMP) sensor housing. Tighten the screws
• the air cleaner (ACL) cover
• the intake manifold between the electronic throttle module and the air cleaner (ACL) cover.

Test drive the engine.