Installing The Engine Control Module (ECM)

Fig 1: Identifying Engine Control Module

Courtesy of VOLVO CARS OF NORTH AMERICA.

CAUTION:

Check that no pins or sockets are damaged on the connector.

Install the surround for the control module box.

Carefully press the engine control module (ECM) down into the grooves on the inside of the control module box. Press down all the way.

Install the tool: 9995722 around the control module.

Move the upper section of the tool forwards as far as it will go. Pull up the tool.

Press the cover into place over the control module. Check that the air ducts are correctly positioned.